|
| |
Up Green Roofs Mechanically Fixed Roofing Membrane Aluminium Vapour Barrier for Roofs Self-Adhesive Roofing Membrane References
Aluminium Vapour Barrier:
-
Our Aluminium Vapour Barrier is designed for use in roof
constructions where extremely high vapour resistance is required, usually where
the roof waterproofing is a singly-ply polymer membrane.
-
Our Aluminium Vapour Barrier has a very high resistance to tearing under
foot traffic and is therefore particularly suitable for use on profiled metal
decking.
-
Our Aluminium Vapour Barrier , correctly installed, is absolutely vapour
tight. It can therefore be used in buildings with extreme internal
conditions (e.g. swimming pools, saunas, kitchens, bathrooms, etc.)
-
Our Aluminium Vapour Barrier , on plywood, oriented strand board, or
timber, can be applied directly without a primer, provided the timber substrate
is free from dust or grease.
-
Our Aluminium Vapour Barrier , where it has to be left exposed as a
temporary waterproofing membrane, must be bonded to the substrate. For
resistance to wind uplift, porous substrates (e.g. concrete or unplaned timber)
should be fully primed with our primer.
-
Laps must be a minimum 40mm wide. These can be sealed without primer.
Alternatively, laps can be sealed by hot-air welding. In all cases, laps
must be rolled down firmly with a hand roller.
-
Our Aluminium Vapour Barrier , when installed on profiled metal decks,
should be laid in the direction of the deck with side laps fully supported on
the corrugations. End laps should be minimum 150mm.
For more information regarding our Aluminium Vapour Barriers,
please fill in the below information request form.
| |
|
